Hydraulic Lift Oil
FS10AS Single Post 8,000 Pound capacity In-Ground Lifts
Installation Instruction Manual (LINK)
FSR28 Two Post 8,000 Pound Capacity
Two Post Lift 12,000 Pound Capacity Upgrade Kit
your existing Globe 8,000 Pound capacity 2-Post Lift to
12,000 Pound capacity)
GLOBE Two Post
12,000 & 15,000 Pound Capacity In-Ground Lifts
DRIVE-ON "Runway Style" In-Ground Lift
Wrap Tape - used during installation to protect pipe LINK
Difference Between "Full- Hydraulic" &
"Semi-Hydraulic" In-Ground Lifts LINK
& Corvette Sports Car Specialty Lift Link
IN-GROUND LIFT PARTS CLICK HERE
Information Click Here
for Info on a New In-Ground Lift? Or are you just fed up with spending
your Company's profit fixing your "High-Pressure In-Ground Lift"
that operates with an electric/hydraulic power unit that someone sold you only 8 to 10 years ago? (Sooner
or later high pressure hydraulic cylinders begin leaking and need
rebuilding or replacement costing about $700.00 each,
sometimes even more.
high-pressure lift, whether it's mounted on the floor
surface or installed underground utilizes an
electric/hydraulic power unit that will need repair or
replacement. The electric motor can burn out or internal
oil pump will wear out and lose the ability
to lift heavier vehicles, and if the power unit needs
replacement, they can cost another $500.00 or
even more depending who you are getting it from.
there are more wearable parts that wear out on a High-Pressure In-Ground Lift
as well as a surface mounted lift. The most commonly
replaced parts include small safety latch air cylinders,
latches, latch pins, springs, internal coiled air hoses
that crack, leak (or just break), high pressure hydraulic
hoses that leak, plunger wear
guide bushings that wear out, hydraulic cylinder seals if
the cylinders can even be rebuilt... cover plate gaskets and
Lifts simply have more parts eventually needing repair or
case, it's better to turn back the clock on Technology
just a little and rely on
Tried and True No Nonsense Design. A GLOBE Low-Pressure
In-Ground Lift usually costs even less than a High Pressure In-Ground Lift!
Additionally, from our experience it's obvious that they
give Globe In-Ground Lift Owners two even three times the
service life out of the Low-Pressure GLOBE Lift
will with most High Pressure Lifts.
Globe in-ground lifts can last 20, 30 even 40 years if
This not that
uncommon for us to see in our line of work... where calls
come in from Customers across the Nation, "Owners of
Low-Pressure In-Ground Lifts" that sometimes are
Three or Four DECADES OLD! They're most
often looking for a simple seal kit to renew the reliable
service that the lift has given them for so many years.
Reliable lifts like these used that many years virtually
pay for themselves many times over, giving a service life that high pressure
can not attain unless the High-Pressure lift Owner spends
1/3 the cost of a brand new lift every
10 years or so just keeping the damn thing working.
THAT GLOBE LOW PRESSURE IN-GROUND LIFTS ARE MISSING...
These Lifts don't need... an underground
container" with multiple high pressure rubber hoses or
small high pressure hose fittings that can break, wear out,
leak oil or fill the cassette up with smelly toxic waste water you have
to pump out occasionally so the internal lift
components won't corrode and fail.
don't need... little air operated lock-latch
air-cylinders that can leak air, corrode, stick open or closed
with operating hardware that fails, like clevis pins,
cotter pins, air line fittings, toggle air-valves, etc. (Usually
when there is a car up on it.)
don't need... coiled plastic air hoses for
safety latch operation that are sealed in the underground container that can get
worn out, pinched and slowly leak
air or even blow apart and fail at the worst possible time...
customers vehicle up in the air
until the lift is repaired.
In-Ground Globe lifts don't need... an electric/hydraulic power unit,
because they're powered by
your shop's existing compressed air supply.
means, your electric bill should stay about the same.)
Low Pressure In-Ground lifts can last up to 20, 30 or 40
sometimes even longer, depending
on the way it was installed and the quality
compressed air being
used to operate it.
is information that should not be ignored when it's time
choose which type of
Lift to purchase for
is always your best bet, if you want to save money and
operating costs.... With only one
moving part per
hydraulic cylinder, Low
Pressure In-ground lifts are
MOST reliable, cost
effective lifts to operate." Smitty
is why we get calls about low-pressure in-ground lifts that
are 30, 40, 50
years old that are still providing reliable lifting service that may just
replacement seal kit to bring it back to top working condition.
piston is kept in good condition, the seals should last for many, many years!
"Tried & True
It actually pays to
repair those 50 to 60 year old lifts rather than replacing them with
a shorter lifespan, high-pressure in-ground lift that has almost a half a hundred parts that begin wearing out the moment you
start really using it.
Regardless of what
any "High Pressure In-Ground Lift Manufacturer" seems to want to
admit, in our opinion any brand 'High Pressure In-Ground Lift' will be lucky to make it past
7 to 9 years of service life without some expensive repair work involved. Either
one or two new high pressure cylinders, a hydraulic hose
perhaps a new electric/hydraulic power unit.
You get the
idea... and YOU get the repair bill.
PSI and even higher
operating pressures on High Pressure In-Ground (and
surface mounted) Lifts mean more stress and wear on the
lifting system and it's many parts involved in the
operating process. That
is the honest truth, no bullshit about it!
lifts use the pressure in your Air Compressor Tank...
stress on the equipment, same service capabilities.
lift companies in the last 10-15 years took a huge gamble when they
stopped making these tried-and-true low-pressure lift designs, gambling that Consumers will buy their over engineered, expensive to maintain high pressure
designs. That's why even now, they continue to claim low-pressure lifts using underground
oil tanks are illegal. The reason for this is that they have to push their
new 'high-pressure designs' on consumers even though many Lift Repair
Technicians agree the old design is the
most cost effective, most reliable design in existence to this very day. Remember
also, that high-pressure means Manufacturers will be making more parts to sell
you for years to come.
another meaning to "HIGH PRESSURE LIFT SALES"
because Low-Pressure Lifts
(like those listed below) are becoming
increasingly popular again.
"High-Pressure Lift Sales Pitch" will someday be
the only way to get someone
buy one of the "high-pressure, high-maintenance
in-ground" money drains.
if anybody tells you "Low-Pressure In-Ground lifts are against the law because
of environmental regulations." You will soon see for yourself, that they
really have NO valid argument. Much of the time
people really don't even know
what the actual regulations even encompass, but now you
this LINK for the Facts & you'll know more than they do
if you like to have your company's lifts in the ground & out
of the way where they belong... and you still have to make
a hole in the floor to install one... so you might as well
buy a lift that you will not have to replace or repair
years to come. GLOBE Low-Pressure Lifts are
the smart way to go!
you have any questions about GLOBE In-Ground Lifts
give me a call 630-678-9010 ask for "Smitty"
Equipment Sales & Service
install them too, within 100 miles of Chicago Illinois)
Call for a special discount for the lift kit you want,
including the installation.
"Will Call" pricing available too.